Table of Contents

Name

gftodvi - make proof sheets from generic font files

Synopsis

gftodvi [ -overflow-label-offset=real ] [ -verbose ] [ gf_file_name ]

Description

This manual page is not meant to be exhaustive. The complete documentation for this version of can be found in the info file or manual Web2C: A TeX implementation.

The gftodvi program converts a generic font (gf) file output by, for example, mf(1) , to a device independent (DVI) file (that can then be typeset using the same software that has already been written for ). The characters in the gf file will appear one per page, with labels, titles, and annotations as specified in Appendix H (Hardcopy Proofs) of The book.

gftodvi uses other fonts in addition to the main gf file. A `gray' font is used to typeset the pixels that actually make up the character. (We wouldn't want all the pixels to be simply black, since then labels, key points, and other information would be lost.) A `title' font is used for the information at the top of the page. A `label' font is used for the labels on key points of the figure. A `slant' font is used to typeset diagonal lines, which otherwise have to be simulated using horizontal and vertical rules. The default gray, title, and label fonts are gray, cmr8, and cmtt10, respectively; there is no default slant font.

To change the default fonts, you can give special commands in your source file, or you can change the fonts online. An online dialog ensues if you end the gf_file_name with a `/'. For example,
gftodvi cmr10.300gf/
Special font substitution: grayfont black
OK; any more? grayfontarea /home/art/don/
OK; any more? slantfont /home/fonts/slantimagen6
OK; any more? <RET>
will use /home/art/don/black as the `gray' font and /home/fonts/slantimagen6 as the `slant' font (this name indicates a font for lines with slope 1/6 at the resolution of an Imagen printer).

The gf_file_name on the command line must be complete. (The program prompts you for it if you don't give it.) Because the resolution is part of the extension, it would not make sense to append a default extension as is done with or DVI-reading software. The output file name defaults to the same root as the gf file, with the dvi extension added. For example, the input file cmr10.2602gf would become cmr10.dvi.

Options

The argument to -overflow-label-offset specifies the distance from the right edge of the character bounding box at which the overflow equations (if any) are typeset. The value is given in points. The default is a little over two inches.

Without the -verbose option, gftodvi operates silently. With it, a banner and progress report are printed on stdout.

Environment

gftodvi looks for gf_file_name using the environment variable GFFONTS. If that is not set, it uses the variable TEXFONTS. If that is not set, it uses the system default.

See tex(1) for the details of the searching.

Files

{gray.tfm,...}
The default fonts.
{gray.mf,...}
The sources.

See Also

tex(1) , mf(1) .
Donald E. Knuth, The book (Volume C of Computers and Typesetting), Addison-Wesley, 1986, ISBN 0-201-13445-4.
Donald E. Knuth et al., ware.

Authors

Donald E. Knuth wrote the program. It was published as part of the ware technical report, available from the Users Group. Paul Richards ported it to Unix.

Table of Contents