We have already discussed the `Next', `Prev', and `Up' pointers which appear at the top of a node. In addition to these pointers, a node may contain other pointers which refer you to a different node, perhaps in another Info file. Such pointers are called cross references, or xrefs for short.
Cross references have two major parts: the first part is called the label; it is the name that you can use to refer to the cross reference, and the second is the target; it is the full name of the node that the cross reference points to.
The target is separated from the label by a colon `:'; first the label appears, and then the target. For example, in the sample menu cross reference below, the single colon separates the label from the target.
* Foo Label: Foo Target. More information about Foo.
Note the `.' which ends the name of the target. The `.' is not part of the target; it serves only to let Info know where the target name ends.
A shorthand way of specifying references allows two adjacent colons to stand for a target name which is the same as the label name:
* Foo Commands:: Commands pertaining to Foo.
In the above example, the name of the target is the same as the name of
the label, in this case Foo Commands.
You will normally see two types of cross reference while viewing nodes: menu references, and note references. Menu references appear within a node's menu; they begin with a `*' at the beginning of a line, and continue with a label, a target, and a comment which describes what the contents of the node pointed to contains.
Note references appear within the body of the node text; they begin with
*Note, and continue with a label and a target.
Like `Next', `Prev', and `Up' pointers, cross references can point to any valid node. They are used to refer you to a place where more detailed information can be found on a particular subject. Here is a cross reference which points to a node within the Texinfo documentation: See section `Writing an Xref' in the Texinfo Manual, for more information on creating your own texinfo cross references.
The following table lists the Info commands which operate on menu items.
menu-digit)
last-menu-item)
menu-item)
This table lists the Info commands which operate on cross references.
xref-item)
Finally, the next few commands operate on menu or note references alike:
move-to-next-xref)
select-reference-this-line) to select the menu or note reference.
move-to-prev-xref)
select-reference-this-line)
Go to the first, previous, next, last section, table of contents.